How to Flash Samsung Monte s5620
Flashing the newer phones is much like any Samsung handset using the Touch Wizard over Samsung OS. We are sharing with you How to Flash Samsung Monte s5620. It really works 100%. I have already flashed my Samsung Monte S5620, hence we are going to share with you.
Follow the below steps :
Prepare Your Computer
1. Install Kies on your computer and make sure it will communicate with your phone, or install only the driver pack.
2. Disconnect your phone and Close NPS.
3. Click “Start” or the Windows logo on the bottom left of your computer screen and click in the search/run box and type msconfig.
4. Select the tab marked “Start Up” and click “disable all” and click ok.
5. Restart the computer and you are ready to flash.
DO NOT! run NPS or Kies again until you have successfully flashed your phone! After you have successfully flashed your phone, you must reset the Windows setting back to there original and restart your computer.
Check List
1. USB cable that came with your phone.
2. Kies or Drivers installed
3. Multiloader software for flashing your Samsung Monte.
4. New firmware (Download from any trusted website)
Warning!
Make sure your phone dose not have sim lock or net lock before you try and flash. Type *#7465625# and make sure the SIMLOCK and NETWORKLOCK is OFF, if it is ON you MUST Unlock it or you will freeze your phone! Or you just type on the screen *2767*3855# and your phone will be factory reset.
Prepare Your Phone for Flashing
1. Make sure Samsung PC Studio/Samsung Kies is installed and communicates with your phone. And unpack the firmware in a folder you can easily find it.
2. Remove the Sim and MicroSD from your phone and replace the battery.
3. Make sure that your phone is off and not connected to the computer.
4. Hold down the “Volume -” button on the left or right side differs, and the “Camera” button on the right, then press the “Power” button (all three buttons need to be pressed together). Your phone should start up into a red\blue on black download screen.)
5. Now run MultiLoader
6. Plug the phone up to the computer.
Multiloader Steps/ Formatting Steps
1. Select the radio button BRCM2153 (for S5620 etc…) Wave S8500 use LSI6410
2. Select Boot Change
3. Full Download
4. Master rom
Now Select these files in this order, you will have to switch between the contained directories as you load file.
5. Boot
6. Amss
7. Apps
8. Rsrc1
9. Rsrc2(Low) (Warning! Do not use Rsrc2 (Mid) your phone may not restart!!!)
10. Factory FS file.
11. CSC (remember this is in a separate folder)
12. SHP
13. SPP
14. PFS
***FOTA and ETC fields are left blank.****
15. Click the Port Search button, it will find your phone and show the com port is ready.
16. Click the download button and be patient, this will only take a few minutes to complete.
17. When it’s finished, it will show “ok complete”.
NOTE - If yours does not restart at this point, take out the battery a few seconds then reinsert it.
18. Unplug the phone from the USB cable, reinstall the sim and SD card.
19. Now with every thing is complete, You can perform a hard reset by typing *2767*3855# into the hand set.
20. When the phone resets type *#1234# into your handset to check your new firmware ver.
NOTE - If your phone fails the flash for any reason, DO NOT TRY AND RESTART IT!!!!! Restart the computer and try the flash again!
